Pioneer VSX-21 - Manual (Page 23)

SET UP
23
<ARB7181>
Preparations
3
Press
% or fi repeatedly to display the name of the
component’s manufacturer.
A list of all available preset codes is provided on page 56.
4
Point the remote toward the component to be controlled,
enter the 3 digit setup code.
When you enter the setup code, the remote emits a power ON/OFF
signal. If the component turns ON or OFF, you have entered the proper
code.
If the component does not turn ON or OFF and there is more than one
setup code, press
! or ⁄ to select another code in step 3 or try
inputting another code (starting again from step 2).
Some manufacturers use several sets of remote control signals and the
first code may not correspond to your component.
Repeat steps 2 through 4 to assign preset codes for as many
components as necessary.
5
Press COMMANDER SET UP to exit the preset mode.
The remote control returns to the previous operation mode.
• When operating a PIONEER’S DVD/LD player, set the
manufacturer code to “000” in the preset mode.
• All codes enrolled in the manufacturer code list can be set
even if a code is not displayed.
• RECEIVER cannot be preset.
dB
SP SIGNAL
SELECT
ANALOG
A
dB
SP SIGNAL
SELECT
ANALOG
A
dB
SP SIGNAL
SELECT
ANALOG
A
dB
SP SIGNAL
SELECT
ANALOG
A
dB
SP SIGNAL
SELECT
ANALOG
A
dB
SP SIGNAL
SELECT
ANALOG
A
dB
SP SIGNAL
SELECT
ANALOG
A
dB
SP SIGNAL
SELECT
ANALOG
A
dB
SP SIGNAL
SELECT
ANALOG
A
memo
Clearing the Remote Control Settings
Clears all presets and restores factory installed presets.
Press the COMMANDER SET UP and 0 at the same time for
more 3 seconds.
• All the multi-control buttons on the remote control blinks. After
blinking three times, all the settings are canceled.
0
COMMANDER
SET UP
DSP MODE
CH.SELECT ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2 3
5
0
6
9 +10
TV/VCR CLASS
7 8
4 1
CN.LEVEL EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
(“VCR” is displayed on VSX-D508)