Pioneer VSX-21 - Manual (Page 40)

40
<ARB7181>
Playback
1
Turn on the power of the playback component.
2
Press RECEIVER to turn on the receiver.
Be sure that the standby indicator turns off on
the front panel.
3
Press FUNCTION to select the source you want to
playback.
The source you want to playback is displayed in the following order:
4
Press SIG. SELECT on the remote control or SIGNAL
SELECT on the front panel to select the input signal
corresponding to the source component.
(Refer to “Switching ANALOG/DIGITAL signal input” on page 29.)
5
Start playback of the component you selected in step 1.
6
Press VOL (+/–) to adjust the volume level in the range of
--- dB (MIN) to 0 dB (MAX).
TUNER MD/TAPE 1 VCR 1
VCR 2 TV/SAT DVD/LD
VIDEO
CD
2
6
3
DVD/LD
VCR 1
TV/SAT CD
TUNER
VCR 2 MD/TAPE
TV CONTROL
RECEIVER
DSP MODE
CH.SELECT ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2 3
5
0
6
9 +10
TV/VCR CLASS
7 8
4 1
CHANNEL
MULTI CONTROL
ENTER
VOL VOL
FQ
FQ
+
–
TV FUNC
RECEIVER TV
MUTING
CN.LEVEL EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
2
3
6
STANDBY
indicator
Other Operations
• Depending on the channel level setting, the MAX volume level
may differ 0 to -10 dB from the level displayed.
• When this receiver is not going to be used for a long time, it is
recommended that you turn off the main power.
memo
4
4