Planet Technology Network Device WAP-4033PE - Manual (Page 10)

Chapter 2 Hardware Installation
Before you proceed with the installation, it is necessary that you have enough information about the
WAP-4033PE.
1. Locate an optimum location for the WAP-4033PE. The best place for your WAP-4033PE is
usually at the center of your wireless network, with line of sight to all of your mobile stations.
2. Assemble the antenna to WAP-4033PE. Try to place them to a position that can best cover your
wireless network. The antenna’s position will enhance the receiving sensitivity.
3. Connect RJ-45 cable to WAP-4033PE. Connect this WAP-4033PE to your LAN switch/hub or a
single PC. If the connected device is IEEE802.3af compliant switch, the WAP-4033PE will power
on. You will not need to plug-in the power adapter in next step.
4. Plug in power adapter and connect to power source. After power on, WAP-4033PE will start to
work.
Note: ONLY use the power adapter supplied with the WAP-4033PE. Otherwise, the product may
be damaged. If you want to reset your WAP-4033PE to default settings, press the Reset
button 5 second. Then release the button and wait for 10 seconds for rebooting.
10