Planet Technology Network Device WAP-4033PE - Manual (Page 20)

Band 2.4GHz (B): It allows to select the transmit rate up to 11Mbps.
2.4GHz (G): It allows to select the transmit rate up to 54Mbps.
2.4GHz (B+G): It provides best performance for 11g transmission when you enable
the AP mode selection to “Mixed mode”.
SSID The SSID (up to 32 printable ASCII characters) is the unique name identified in a
WLAN. The ID prevents the unintentional merging of two co-located WLANs.
Please make sure that the SSID of all stations in the same WLAN network are the
same. The default SSID is “default”.
Channel Number Select the appropriate channel from the list provided to correspond with your
network settings. Channels differ from country to country.
Channel 1-11 (North America)
Channel 1-14 (Japan)
Channel 1-13 (Europe)
Associated Clients You may press “Show Active Clients” button to check the connected client
information. After the button pressed, you will see the dialog box as below:
You may press “Refresh” to get the new client table or “Close” to close this dialog
box.
MAC Address 1 ~6 If you want to bridge more than two wired Ethernet networks together with wireless
connection, you have to enter the MAC addresses of otherWAP-4033PEs that with
join the bridging work into the fields.
Set Security IF you want to enable security to protect your wireless connection. Please press
“Set Security” button and refer to section “3.2.8 Security setting for bridge mode” to
configure the detail settings.
After configuration complete, please click “Apply” button to save the configuration. Then you will
20