8 security setting of bridge mode, Security setting of bridge mode – Planet Technology Network Device WAP-4033PE User Manual

Page 22

Advertising
background image

same. The default SSID is “default”.

Channel Number

Select the appropriate channel from the list provided to correspond with your

network settings. Channels differ from country to country.

Channel 1-11 (North America)

Channel 1-14 (Japan)

Channel 1-13 (Europe)

Associated Clients You may press “Show Active Clients” button to check the connected client

information. After the button pressed, you will see the dialog box as below.

You may press “Refresh” to get the new client table or “Close” to close this dialog

box.

WLAN MAC

Keep default setting: WAP-4033PE will use it’s own MAC address to access the

wireless LAN.

Press “MAC Clone” button: It will use PC’s MAC address to access the wireless

LAN.

Root AP SSID

In “Universal Repeater mode”, this device can act as a station to connect to

a Root AP. You should assign the SSID of the Root AP here.

After configuration complete, please click “Apply” button to save the configuration. Then you will

see a screen to prompt you the settings are save successfully. You may press “Continue” for

configure other settings or “Apply” to restart WAP-4033PE with new configuration.

3.2.8 Security

setting of bridge mode

In “AP Bridge-Point to Point mode”, ““AP Bridge-Point to Multi-Point mode” and “AP

Bridge-WDS mode”, you can click “Set Security” to add encryption for the communication

between the bridged access points. This can protect your wireless network.

22

Advertising