Planet Technology Network Device WAP-4033PE - Manual (Page 16)

3.2.3 Station - Infrastructure Mode
Served as a wireless station (infrastructure). Connected to a PC or a small LAN, it allows the
PC or small LAN able to access the wireless network via Access Point.
Parameter
Description
Mode Shows the current operation mode. You may set WAP-4033PE to other
operating mode by select other operating mode.
Band 2.4GHz (B): It allows to select the transmit rate up to 11Mbps.
2.4GHz (G): It allows to select the transmit rate up to 54Mbps.
2.4GHz (B+G): It provides best performance for 11g transmission when
you enable the AP mode selection to “Mixed mode”.
SSID Please make sure the SSID of the wireless network that you will
connected and enter the correct SSID in this field. The default SSID is
“default”.
WLAN MAC Keep default setting: WAP-4033PE will use it’s own MAC address to
access the wireless LAN.
Press “MAC Clone” button: It will use PC’s MAC address to access the
wireless LAN.
After configuration complete, please click “Apply” button to save the configuration. Then you will
see a screen to prompt you the settings are save successfully. You may press “Continue” for
configure other settings or “Apply” to restart WAP-4033PE with new configuration.
16