Proxim ORiNOCO AP-2500 - Manual (Page 170)

170
Commands
Reboot
Use the Reboot tab to save configuration changes (if any) and reset the AP-2500. Entering a value of 0 (zero) causes
an immediate reboot. Note that Reset, described below, does not save configuration changes.
CAUTION !
Rebooting the AP-2500 will cause all users who are currently connected to lose their connection to the
network until the AP-2500 has completed the restart process and resumed operation.
Figure 7-3 Reboot Command Screen
Reset
Use the Reset tab to restore the AP-2500 to factory default conditions. The AP-2500 may also be reset from the
RESET button located on the side of the unit. Since this will reset the Access Point’s current IP address, a new IP
address must be assigned. Refer to
Recovery Procedures for more information.
CAUTION !
Resetting the AP-2500 to its factory default configuration will permanently overwrite all changes that have
made to the unit. The AP-2500 will reboot automatically after this command has been issued.