Proxim ORiNOCO AP-2500 - Manual (Page 203)

203
Using the Command Line Interface
NOTE
The distance between APs should not be approximated. It is calculated by means of a manual Site Survey, in
which an AP-2500 unit is set up and clients are tested throughout the area to determine signal strength and
coverage, and local limits such as physical interference are investigated. From these measurements the
appropriate cell size and density is determined, and the optimum distance between APs is calculated to suit
your particular business requirements.
Set the Multicast Rate
NOTE
The Distance Between APs must be set before the Multicast Rate.
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B
[Device Name]>set wif <3 or 4> multrate <1,2,5.5,11 (Mbps)>
This feature is only available for 802.11b wireless cards.
Set Ethernet Speed and Transmission Mode
[Device Name]>set etherspeed <value
(see below)>
[Device Name]>reboot 0
Set Interface Management Services
Set Communication Ports
[Device Name]>set httpport <HTTP port number
(default is 80)>
[Device Name]>set telport <Telnet port number (default is 23)>
Set Session Timeouts
[Device Name]>set tellogintout <time in seconds>
[Device Name]>set telsessiontout <time in seconds>
Ethernet Speed and Transmission Mode Value
10 Mbit/s - half duplex 10halfduplex
10 Mbit/s - full duplex 10fullduplex
10 Mbit/s - auto duplex 10autoduplex
100 Mbit/s - half duplex 100halfduplex
100 Mbit/s - full duplex 100fullduplex
Auto Speed - half duplex autohalfduplex
Auto Speed - auto duplex autoautoduplex (recommended)