Proxim ORiNOCO AP-2500 - Manual (Page 212)

212
Using the Command Line Interface
Ethernet Interface Parameters
Management Parameters
IP Access Table Parameters
When creating table entries, you may either specify the argument name followed by argument value or simply entering
the argument value. When only the argument value is specified, then enter the values in the order depicted by the
following table. CLI applies default values to the omitted arguments. Due to the nature of the information, the only
argument that can be omitted is the “comment” argument.
Access Control Parameters
NOTE
Both the IP Access Table Parameters and the Access Control Parameters determine which IP addresses are
allowed to manage the AP over the Ethernet interface.
Name Type Values Access CLI Parameter
Ethernet Interface Group N/A R ethernet
Speed Integer 10halfduplex
10fullduplex
10autoduplex
100halfduplex
100fullduplex
autohalfduplex
autoautoduplex (default) RW etherspeed
MAC Address PhyAddress N/A R ethermacaddr
Name Type Values Access CLI Parameter
IP Access Table Table N/A R mgmtipaccesstbl
Table Index Integer User Defined N/A index
IP Address IpAddress User Defined RW ipaddr
IP Mask IpAddress User Defined RW ipmask
Comment (optional) DisplayString User Defined RW cmt
Status (optional) Integer enable
disable
delete RW status
Name Type Values Access CLI Parameter
Access Control Group N/A R accessctl
Access Control On Integer disable (0)
enable (1) RW accessControlOn
Access Control Table Table N/A RW acIpRangeTable
Access Control Table
Index Integer N/A R acIpRangeIndex
Access Control Range
Starting IP Address IpAddress User Defined RW acIpRangeStartAddress
Access Control Range
Starting IP Address IpAddress User Defined RW acIpRangeEndAddress
Access Control IP Table
Entry Status RowStatus active (1),
notInService (2),
notReady (3),
createAndGo (4),
createAndWait (5),
destroy (6) RW acIpRangeEntryStatus