Panasonic DIGA DMR-EA18 User Manual
Page 65
65
RQT9048
Ref
erence
Playback Issues
Picture
Page
TV reception worsens after
connecting the unit.
This can occur because the signals are being divided between the
unit and other equipment. It can be solved by using a signal booster,
available from electronics retailers.
•
−
The images from the unit do
not appear on the TV.
Picture is distorted.
Make sure recorder is connected to an appropriate AV input of the TV.
•
8
Make sure the TV’s input setting (e.g., VIDEO 1) is correct.
•
−
The TV isn’t compatible with progressive signals. Press and hold
[g] and [q] on the main unit for about 5 seconds. The setting will
change to interlace.
When connecting with component video cables to a television, check
if there is also an HDMI cable connected to an amplifier. If so, turn off
the equipment connected with an HDMI cable, and set “HDMI Priority”
to “Off” in the Setup menu.
To output video from a device connected with an HDMI cable, set
“HDMI Priority” to “On” in the Setup menu.
Picture may not be seen when more than 4 devices are connected
with HDMI cables. Reduce the number of connected devices.
•
•
•
•
−
48
48
−
Status messages do not
appear.
Select “Automatic” in “Status Messages” in the Setup menu.
•
46
The 4:3 aspect ratio picture
expands left and right.
Screen size is wrong.
If you connect an HDMI cable, set “HDMI Output Display Aspect” in
the Setup menu to “Normal”.
•
49
Check the settings for “TV Aspect”, “4:3 TV settings for DVD-Video”,
or “4:3 TV settings for DVD-RAM” in the Setup menu.
•
47, 48
There is a lot of after-images
when playing video.
Set “DNR” in the Video menu to “Off”.
•
39
When playing DVD-Video
using progressive output, one
part of the picture momentarily
appears to be doubled up.
This problem is caused by the editing method or material used on
DVD-Video, but should be corrected if you use interlaced output.
When you use the HDMI AV OUT terminal for video output, follow the
steps below:
(1) Connect this unit to the TV with any cable except the HDMI cable.
(2) Set “HDMI Priority” in the Setup menu to “Off” (
➔ 48).
(3) Set “Component Output Signal” in the Setup menu to “480i” (
➔ 48).
•
•
48
−
There is no apparent change
in picture quality when making
adjustments in the Video menu
using the on-screen menus.
The effect cannot be seen with certain types of video.
•
−
Playback images of DVD-Video
are not smooth.
When you set “Progressive/24p” to “24p”, images of DVD-Video
incompatible with 24p may not be played smoothly. Set to “Auto1” or
“Auto2”.
•
39