Panasonic DIGA DMR-EA18 - Manual (Page 8)

8
RQT9048
Basic Connection
Connecting to a Television and a Set Top Box
Consult your set top box provider about the appropriate Set Top Box to use.
Additional coaxial cable and audio/video (AV) cable are required.
Note: The terminals on the rear of your TV and Set Top Box may not appear as shown below.
Please read terminal labels carefully to ensure correct connections.
P R
P B
Y
COMPONENT
VIDEO OUT
OX
L
OPTICAL
DIGITAL AUDIO OUT
(PCM/BITSTREAM) R-AUDIO-L VIDEO S VIDEO
IN1
OUT AV OUT
AUDIO OUT
R L
VIDEO
OUT
RF IN/
SATELLITE IN RF OUT
VHF/UHF
RF IN
AUDIO IN
R L
VIDEO
IN
Rear of Set Top Box
Rear of this unit
step
6
SET TOP BOX
CONTROL
step
3
step
7
Red White Yellow
Red White Yellow
step
4
step
5
Red White Yellow
step
1
step
2
Rear of TV
• The Set Top Box Control
cable is necessary for
operating a set top box with
this unit’s remote control.
• Place the Set Top Box
Control cable in front of the
signal sensor of the set top
box.
Read the set top box operating
instructions regarding
positioning of the signal
sensor.
If necessary, use the double
sided adhesive tape (included)
to secure the Set Top Box
Control cable to a flat surface.
Red White Yellow
AC IN AC IN AC IN
Cable from the wall
or satellite antenna
To a household
AC outlet
(AC 120 V, 60 Hz)
75 Ω coaxial cable from the wall or satellite antenna to the “ RF IN” on the Set Top Box.
75 Ω coaxial cable from the “ RF OUT” on the Set Top Box to the “VHF/UHF RF IN” on the TV.
Audio/video cable (included) from the “ OUT” on the unit to the “AV IN” on the TV.
Audio/video cable from the “ AV OUT” on the Set Top Box to the “IN1” on the unit.
Connect the Set Top Box Control cable (included) to the back of this unit.
Install the Set Top Box Control cable (included) in front of Set Top Box.
AC power supply cord (included) from the “
AC IN~” on the unit to a household AC outlet.
•
•