PB Heat Gas Boiler User Manual

Page 33

Advertising
background image

31

B. LIGHTING AND OPERATING

PROCEDURES

START-UP PROCEDURES

FOR YOUR SAFETY READ BEFORE OPERATING

OPERATING INSTRUCTIONS

TO TURN OFF GAS TO APPLIANCE

A. This appliance does not have a pilot. It is equipped

with an ignition device which automatically lights the
burner. Do not try to light the burner by hand.

B. BEFORE OPERATING smell all around the appliance

area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.
• Do not touch any electric switch; do not use any

phone in your building.

• Immediately call your gas supplier from a neighbor’s

phone. Follow the gas suppliers’ instructions.

• If you cannot reach your gas supplier, call the

fire department.

C. Use only your hand to turn the gas control knob. Never

use tools. If the handle will not turn by hand, don’t try
to repair it, call a qualified service technician. Force or
attempted repair may result in a fire or explosion.

D. Do not use this appliance if any part has been under

water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.

1

1. STOP! Read the safety information above.

1

2. Set the thermostat to lowest setting.

1

3. Turn off all electric power to the appliance.

1

4. This appliance is equipped with an ignition device

which automatically lights the burner. Do not try to light
the burner by hand.

1

5. Remove front cover.

1

6. Turn gas shutoff valve clockwise to “off”. Handle will be

vertical, do not force.

1

7. Wait five (5) minutes to clear out any gas. If you then

smell gas, STOP! Follow “B” in the safety information
above on this label. If you don’t smell gas, go to next
step.

1

8. Turn gas shutoff valve counterclockwise to “on”.

Handle will be horizontal

1

9. Install Front Cover.

10. Turn on all electric power to appliance.

11. Set thermostat to desired setting.

12. If the appliance will not operate, follow the instructions

“To Turn Off Gas To Appliance” and call your service
technician or gas supplier.

1. Set the thermostat to lowest setting.

2. Turn off all electric power to the appliance if service is

to be performed.

3. Remove front cover.

4. Turn gas shutoff valve clockwise to “off”. Handle will be

vertical. Do not force.

5. Install front cover.

WARNING: If you do not follow these instructions exactly, a fire or explosion may
result, causing property damage, personal injury or loss of life.

Advertising