Pioneer DVH-P5900MP - Manual (Page 16)

Non-RDS or MW/LW
1 Band indicator
2 Preset number indicator
3 Frequency indicator
4 Stereo (5) indicator
Shows when the selected frequency is being
broadcast in stereo.
1 Press SOURCE to select the tuner.
2 Press BAND to select a band.
Press BAND until the desired band is dis-
played, FM1, FM2, FM3 for FM or MW/LW.
3 To perform manual tuning, briefly press
c or d.
4 To perform seek tuning, press and hold
c or d for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by briefly pressing
c or d.
# If you press and hold c or d you can skip sta-
tions. Seek tuning starts as soon as you release
the button.
Storing and recalling broadcast
frequencies
If you press any of the preset tuning buttons 1
to 6 you can easily store up to six broadcast
frequencies for later recall with the touch of a
button.
! Up to 18 FM stations, six for each of the
three FM bands, and six MW/LW stations
can be stored in memory.
% When you find a frequency that you
want to store in memory, press one of pre-
set tuning buttons 1 to 6 and hold until the
preset number stops flashing.
The number you have pressed will flash in the
preset number indicator and then remain lit.
The selected radio station frequency has been
stored in memory.
The next time you press the same preset tun-
ing button the radio station frequency is re-
called from memory.
# You can also use a and b to recall radio sta-
tion frequencies assigned to preset tuning but-
tons
1 to 6.
Introduction of advanced
operations
1 Function display
Shows the function status.
2 LOC indicator
Shows when local seek tuning is on.
% Press FUNCTION repeatedly to switch
between the following functions:
BSM (best stations memory)
—REG (regional)
—LOCAL (local seek tuning)—TA (traffic an-
nouncement standby)
—AF (alternative fre-
quencies search)
# If MW/LW band is selected, you can only se-
lect
BSM or LOCAL.
# To return to the frequency display, press
BAND.
# If you do not operate functions within about
30 seconds, the display is automatically returned
to the ordinary display.
Operating this unit
En
16
Section
03