Pioneer DVH-P5900MP - Manual (Page 76)

12 Store the microphone carefully in the
glove compartment.
Store the microphone carefully in the glove
compartment or any other safe place. If the
microphone is subjected to direct sunlight for
an extended period, high temperatures may
cause distortion, color change or malfunction.
Setting the speaker setting
You need to make with/without (or yes/no) and
size (bass reproducing capacity) selection/ad-
justments depending on the installed speak-
ers. The size needs to be set to
LRG (large) if
the speaker is capable of reproducing sounds
of about 100 Hz or below. Otherwise select
SML (small).
! Low frequency range is not output if the
subwoofer is set to OFF and the front and
rear speakers set to SML or OFF.
! It is imperative that non-installed speakers
be set to OFF.
! Set the front or rear speaker to LRG if the
speaker is capable of reproducing bass
content, or if no subwoofer is installed.
1 Press AUDIO and hold until AT EQ ap-
pears in the display, then press AUDIO to
select FRONT.
2 Press c or d to select the speaker to be
adjusted.
Each press of c or d selects the speaker in
the following order:
FRONT (front speakers)
—CENTER (center
speaker)
—REAR (rear speakers)—SUB.W
(subwoofer)
—PHASE (subwoofer setting)
# You can switch to PHASE only when the sub-
woofer has been set to
ON.
3 Press a or b to select the correct size
for the selected speaker.
Each press of a or b selects the size in the fol-
lowing order:
SML (small)
—LRG (large)—OFF (off)
# You cannot select OFF, when FRONT (front
speakers) have been selected.
# You can select ON or OFF, when SUB.W (sub-
woofer) has been selected.
# You can switch REV (reverse phase) or NOR
(normal phase), when
PHASE (subwoofer setting)
has been selected.
4 Press BAND to return to the playback
display.
Correcting the subwoofer
’s phase
If trying to boost the bass output of the sub-
woofer doesn
’t do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofer
’s output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1 Press AUDIO and hold until AT EQ ap-
pears in the display, then press AUDIO to
select FRONT.
2 Press c or d to select the subwoofer.
Each press of c or d selects the speaker in
the following order:
FRONT (front speakers)
—CENTER (center
speaker)
—REAR (rear speakers)—SUB.W
(subwoofer)
—PHASE (subwoofer setting)
3 Press a to turn the subwoofer output
on.
4 Press d to select PHASE (subwoofer
setting).
5 Press a or b to select the subwoofer
output phase.
Press a to select NOR (normal phase). Press
b to select REV (reverse phase).
Available accessories
En
76
Section
04