Operating this unit, Correcting distorted sound, Resetting the audio functions – Pioneer DVH-P5900MP User Manual
Page 54
1
Press FUNCTION to select TV.
2
Press c or d to select an appropriate
TV signal.
PAL
—SECAM
Note
About your country TV signal, consult with your
nearest Pioneer dealer.
Correcting distorted sound
Only when the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you can
operate this function.
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to
LOW. Normally, leave the set-
ting at
HIGH to ensure quality sound.
1
Press FUNCTION to select D.ATT.
2
Press c or d to select LOW or HIGH.
Resetting the audio functions
Only when the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you can
operate this function.
You can reset audio functions other than the
following settings.
! Volume setting (refer to Adjusting the vo-
! Listening position setting (refer to Using
the position selector on page 70)
! Fader/balance setting (refer to Using bal-
! SLA (source level adjustment) setting (refer
to Adjusting source levels on page 72)
! Dynamic range control (refer to Using the
dynamic range control on page 71)
! Direct control setting (refer to Using the di-
! Down-mix setting (refer to Using the down-
1
Press FUNCTION to select A.RESET.
2
Press a to display RESETOK?.
# To cancel resetting the audio functions, press
BAND.
3
Press d to display REALLY?.
# To cancel resetting the audio functions, press
BAND.
4
Press a to reset audio functions.
COMPLETE appears in the display.
Operating this unit
En
54
Section
03