Pioneer DVH-P5900MP - Manual (Page 77)

6 Press BAND to return to the playback
display.
Note
When playing a 2-channel mono source with Pro
Logic II turned on, there may be occasions when
the following will occur:
! No audio is outputted if the center speaker
setting is SML or LRG and no center speaker
is installed.
! Audio is heard only over the center speaker if
installed and the center speaker setting is
SML or LRG.
Selecting a cross-over frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to
SML, you can select a fre-
quency, under which sounds are reproduced
through a
LRG speaker or subwoofer.
1 Press AUDIO and hold until AT EQ ap-
pears in the display, then press AUDIO to
select HPF.
2 Press c or d to select the speaker to be
adjusted.
Each press of c or d selects the speaker in
the following order:
F (front speakers)
—C (center speaker)—R
(rear speakers)
—S (subwoofer)
3 Press a or b to select cross-over fre-
quency for the selected speaker.
Each press of a or b selects cross-over fre-
quencies in the following order:
63
—80—100—125—160—200 (Hz)
4 Press BAND to return to the playback
display.
Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofer
’s L.P.F. (low-pass
filter) and that of the SML speaker H.P.F. (high-
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to
OFF and other
speakers are set to LRG or OFF.
Adjusting the speaker output
levels
Speaker level can be adjusted finely by listen-
ing to an audio output. First, use test tone to
adjust the approximate speaker level, and then
use this function to adjust finely.
1 Press AUDIO and hold until AT EQ ap-
pears in the display, then press AUDIO to
select FRT-L.
2 Press c or d to select the speaker to be
adjusted.
Each press of c or d selects the speaker in
the following order:
FRT-L (front speaker left)
—CENTER (center
speaker)
—FRT-R (front speaker right)—
REAR-R (rear speaker right) —REAR-L (rear
speaker left)
—SUB.W (subwoofer)
# You cannot select speakers whose size is set
at
OFF. (Refer to Setting the speaker setting on
the previous page.)
3 Press a or b to adjust the speaker out-
put level.
Each press of a or b increases or decreases
the speaker output level.
+10 to
–10 is dis-
played as the level is increased or decreased.
4 Press BAND to return to the playback
display.
Available accessories
En
77
Section
04
A
vailable
accessories