Pioneer DVH-P5900MP - Manual (Page 43)

Display Equalizer curve
CUSTOM 1 Custom 1
CUSTOM 2 Custom 2
EQ FLAT Flat
SUPER BASS (S-BASS) Super bass
! CUSTOM 1 and CUSTOM 2 are adjusted
equalizer curves that you create. Adjust-
ments can be made with a 7-band graphic
equalizer.
! When EQ FLAT is selected no supplement
or correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
EQ FLAT and a set equalizer curve.
% Press EQ to select the equalizer.
Press
EQ repeatedly to switch between the fol-
lowing equalizers:
POWERFUL (PWRFL)
—NATURAL—VOCAL—
CUSTOM 1
—CUSTOM 2—EQ FLAT—
SUPER BASS (S-BASS)
Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of
EQ FLAT, can be adjusted to a
fine degree (nuance control).
1 Press AUDIO to select PWRFL.
PWRFL appears in the display.
If the equalizer curve has been previously se-
lected, the curve of that previously selected
will be displayed instead of
PWRFL.
2 Press c or d to select an equalizer
curve.
3 Press a or b to adjust the equalizer
curve.
Each press of a or b increases or decreases
the equalizer curve respectively.
+6 to
–4 (or –6) is displayed as the equalizer
curve is increased or decreased.
# The actual range of the adjustments are differ-
ent depending on which equalizer curve is se-
lected.
# The equalizer curve with all frequencies set to
0 cannot be adjusted.
Adjusting 7-band graphic equalizer
For CUSTOM 1 and CUSTOM 2 equalizer
curves, you can adjust the level of each band.
! A separate CUSTOM 1 curve can be cre-
ated for each source. If you make adjust-
ments when a curve other than
CUSTOM 2
is selected, the equalizer curve settings will
be memorized in
CUSTOM 1.
! A CUSTOM 2 curve can be created com-
mon to all sources. If you make adjust-
ments when the
CUSTOM 2 curve is
selected, the CUSTOM 2 curve will be up-
dated.
1 Recall the equalizer curve you want to
adjust.
See Recalling equalizer curves on the previous
page.
2 Press AUDIO to select 7-band graphic
equalizer adjustment.
Frequency and the level (e.g.,
50HZ 0) appears
in the display.
3 Press c or d to select the equalizer
band to adjust.
Each press of c or d selects equalizer bands
in the following order:
50Hz
—125Hz—315Hz—800Hz—2kHz—
5kHz
—12.5kHz
4 Press a or b to adjust the level of the
equalizer band.
Each press of a or b increases or decreases
the level of the equalization band.
Operating this unit
En
43
Section
03
Operating
this
unit