Accessing this pr oduct, Viewing camera images from the wan (internet) side – Panasonic BBHGW700A User Manual
Page 19
19
[For assistance, please call: 1-800-272-7033]
Operating Instructions
Accessing
This Pr
oduct
Viewing Camera Images from the WAN (Internet) Side
This function allows you to view camera images by accessing the camera portal from the WAN side.
Note
To view camera images from the Internet, it is necessary to connect this product to your modem
and have an Internet subscription. Regarding how to connect to the Internet see Installation/
Troubleshooting and Using the Functions (see page 21 onwards).
1.
Start the web browser.
2.
Enter "http:// IP address(WAN) or URL : port
number" into the web browser's address bar.
•
(e.g. http://10.75.68.251:80
http://www.example.com:80
The default port number is 80. If the port
number is 80, there is no need to enter it.)
Notes
•
It is possible to check the status of the IP address (WAN) on the setup pages. (see page 102)
•
When using this product with a service that is not a static IP service, the IP address
changes. It is recommended that you use the Viewnetcam.com service. (see page 55)
3.
Press [Enter].
•
The camera portal is displayed.
Notes
•
In order to open an IPv6 camera with an
IPv6 address using the Camera Portal, first,
register the camera's IPv6 address with an
IPv6 compatible DDNS service (e.g.
Viewnetcam.com). Then, register the
camera manually on this product (see page
43), and set it on the Camera Portal.
•
In order to use IPv6 your local network,
your ISP must support IPv6. Please contact
your local network administrator or ISP if
you have any questions.
•
If an exclamation mark is displayed, click it
and the camera's password window is
displayed. Perform the settings on each
page. Setting Allow Access from the
Internet to Enable, displays the camera
images on the Camera Portal over the
Internet. Setting Disable only displays the
camera images on the Camera Portal when
accessing from the LAN side.
(It is displayed when a factory default
camera is connected.)
•
If a key mark is displayed, click it and enter
that camera's user name and password.
(If camera authentication has been set up,
the key mark will be displayed.)