Panasonic BBHGW700A - Manual (Page 76)

Operating Instructions
76
PPPoE
This function allows you to connect/disconnect PPPoE connection, when using it to connect with an
ISP. When the charge for Internet access is metered according to the contract with your ISP, select
Manual Connection.
The window (right) is displayed by clicking Add.
Static DHCP Select Enable or Disable. When Enable is selected, the entry table
stabilizes the IP address set in the table, on the PC with the MAC
address set in the table. When Disable is selected, even if the other
headings are set they will not function. They will function, however, if
Enable is re-selected.
IP Address (LAN) Enter the IP address that you want to stabilize of the corresponding
PC.
MAC Address Enter the LAN card's MAC address of the corresponding PC. Enter
two numbers or letters between A-F (a-f) each time, separated by a
colon, ":" (e.g. 01:23:45:ab:cd:ef).
The window (right) is displayed by clicking PPPoE.
Always Connected whenever the power is turned on. This is the default
setting. You can disconnect manually on the PPPoE connection
page. (see page 99)
Manual Only connected when Connect is selected on the PPPoE connection
page. (see page 99) To disconnect PPPoE connection, click
Disconnect on the PPPoE connection page.