Additional information 15 – Pioneer DVR-LX70 User Manual
Page 130
Additional information
15
130
En
• Repairing disc.
• Repairing the HDD.
During recording, the power was cut. This display
appears when the power is restored.
• Could not repair the disc.
The recorder was unable to repair the disc after a
power cut. The contents of the recording will be
lost.
• Overheating has stopped operation.
Press DISPLAY to clear message.
The internal temperature of the recorder has
exceeded the operating limit. If this message
reappears, please ask your nearest Pioneer-
authorized service center or your dealer to carry
out repairs.
• HDD optimization is recommended.
This can be done using Disc Setup.
The HDD should be optimized (basically, HDD
housekeeping) to maintain playback and recording
performance.
• Please perform HDD optimization.
This can be done using Disc Setup.
The HDD is in more urgent need of optimization in
order to maintain performance.
• The HDD has not been sufficiently
optimized. Please optimize again.
If this message appears repeatedly after
optimizing the HDD it is likely that there is not
enough free space on the HDD for optimization to
complete properly. Please erase some titles from
the HDD and optimize again.
• An error occurred. Please consult the
service center. Note that contents on
the HDD may be erased when servicing
this unit.
This message is displayed when information from
the HDD cannot be read. The HDD may be
damaged or broken. Please ask your nearest
Pioneer-authorized service center or your dealer to
carry out repairs.
• The Hard Disk Drive info is incorrect.
Use the Disc Setup menu to reinitialize.
As the HDD info cannot be properly read, no new
recordings can be made. Reinitializing the HDD
(page 104) may result in your being able to make
recording again. Note that reinitializing the HDD
will erase all recorded contents, including
protected files.
• There is no DV input or the input
signal is unrecordable.
No signal was detected at the
DV IN jack. This may
appear if a blank section of DV tape is playing in
the connected camcorder.
• No DV camcorder connected.
The camcorder is not connected properly, or the
camcorder is switched off.
• You cannot connect more than one
DV camcorder at a time.
This recorder’s DV jack supports connection to
just one camcorder.
• Cannot operate the DV camcorder.
This recorder cannot operate the DV camcorder.
Try switching off the camcorder then turn it back
on again.
Message
Explanation/Action
DVRLX70_TF_EN.book 130 ページ ２００７年８月１日 水曜日 午後４時１４分