Matrix settings, Matrix settings –56 – Polycom C16 User Manual
Page 272
Design Guide for the Polycom SoundStructure C16, C12, C8, and SR12
9 - 56
Matrix Settings
The matrix that is created by SoundStructure Studio is shown in the following
figure.
To add the reinforcement of the wireless and lectern microphones, the lectern
microphone will only be reinforced into Amplifier zones 2 and 3 and not in
Amplifier zone 1. Because the wireless microphone may be in any zone, it is
reinforced into all zones.
To simplify the system, a presenter group will be created and the wireless
microphone and lectern mic will be added to the group. The wireless and lec-
tern microphone can remain in the “Mics” group so that all the microphones
may be muted by simply sending a mute command to the “Mics” group.
In addition the multiple matrix crosspoints of the reinforced mics can be
selected, and at one time, the value set to -6dB and the Snd Reinforcement ver-
sion of the input processing selected. This will result in the light blue
background for the reinforced crosspoints. The reinforcement level can be
adjusted if, for instance, the lectern microphone needs to be reinforced at a
louder level to the rear of the room.