Pioneer DVR-745H-S - Manual (Page 115)

The Initial Setup menu 14
115
En
Colour RGB (0–255) Use if colours are weak and black appears to ‘float’
on the
RGB (16–235) setting.
RGB (16–235) Use this setting if colours appear overly rich and the
black too deep on the
RGB (0–255) setting.
YCbCr 4:2:2 The video signal is output as a 10-bit YCbCr 4:2:2
component signal. This is the standard setting for
HDMI-compatible devices.
YCbCr 4:4:4 The video signal is output as a 8-bit YCbCr 4:4:4
component signal.
• Depending on the connected device some settings may not be available.
• When a DVI device is connected, the YCbCr 4:2:2 and YCbCr 4:4:4 options are not available.
Audio Output Auto • Dolby Digital, MPEG and DTS sources are output as
a bitstream signal. However, depending on the
Audio Out setting, number of audio channels, and
the HDMI-connected device, Linear PCM audio may
be output.
PCM All audio signals are converted to Linear PCM
(except DTS).
Bitstream Priority Select if the connected device is compatible with
bitstream audio.
This setting is not available when a DVI device is connected .
Video Priority Mode HDMI • Select for high quality picture output on a connected
HDMI display. However, on this setting the YNR and
Detail picture quality settings are not effective for
analog video, and component video will be set to
interlaced.
Component Select if you want the YNR and Detail picture quality
settings to be effective for both HDMI and analog
video output, or if
Component Video Out is set to
Progressive while an HDMI display is connected
(page 108).
When watching video on an HDMI display, use the
HDMI setting.
Options
On Screen Display On • The recorder displays operation displays ( Stop , Play ,
etc.) on-screen.
Off Switches off the on-screen operation displays.
Setting Options Explanation
DVR745H_IBD_EN.book 115 ページ ２００６年７月２７日 木曜日 午後４時１１分