Pioneer DVR-745H-S - Manual (Page 40)

Recording 05
40
En
Timer recording using the G-
Code™ programming system
This system makes programming timer
recordings very simple. Most TV guides
publish G-Code programming numbers with
their program details. If you want to make a
timer recording of a program, you just input
the corresponding code. The date, start, stop
and channel settings are made
automatically. All you have to do is tell the
recorder the recording mode, and whether
it’s a once-only recording or a regular
recording.
Note that if the country setting is incorrect
(set in the Setup Navigator), timer
recordings made using the G-Code
programming system may not work as
expected.
1 Press ‘G-Code’ to display the G-Code
program screen.
You can also access this screen from the
Home Menu (press
HOME MENU , select
Timer Recording , then
G-Code system ).
• Use the number buttons to enter the G-
Code programming number. (To clear
the last digit entered, press
CLEAR .)
• You can also use the / / /
buttons to select digits from the on-
screen display.
2 After making the settings, select
‘Enter’ and press ENTER.
The timer recording screen appears with the
timer program you just set.
3 Confirm that the settings are correct.
If the channel number isn't displayed, use
the
/ buttons to highlight CH , then use
the / buttons to set the correct channel
number.
• If the channel number is set, but
incorrectly, set up the guide channel
(see
G-Code CH Setting on page 107).
4 Select ‘Store Program’ to finish.
• Other options in the same menu panel
allow you to name the program, and
change the recording destination and/or
recording mode.
Checking/editing timer recording
settings
You can check and/or edit the timer
recording settings made by the G-Code
system by selecting
Details from the G-
Code# setting screen.
1 Select ‘Details’ from the G-
Code# setting screen.
The Timer Program Set screen appears,
filled out with the timer recording details.
2 Check and edit the fields as
necessary.
See Setting a manual timer recording on
page 41 for more on this.
3 Select ‘Store Program’ to save
the timer program and exit.
G-Code#
1 3
4 5 6
7 8 9
0 Clear Enter
Details
Cancel
2
ENTER
ENTER
DVR745H_IBD_EN.book 40 ページ ２００６年７月２７日 木曜日 午後４時１１分