Pioneer DVR-745H-S - Manual (Page 54)

Playback 06
54
En
Playing Video CD/Super VCDs
The table below shows the basic playback
controls for Video CD/Super VCDs.
Some discs feature Playback Control (PBC
for short) menus. These discs show PBC in
the display when you load them and display
a menu on-screen from where you can select
what to watch. 1
Press to start playback.
Video CD only: If RESUME is dis-
played on-screen, playback
starts from the place last
stopped.
Press to stop playback.
Video CD only: You can resume
playback from the same point
by pressing
PLAY . (Press
STOP again to cancel the
resume function.)
Pauses playback, or restarts
playback when paused.
Press to start scanning. Press
repeatedly to increase the scan-
ning speed.
Press to skip to previous/next
track.
When a PBC menu is dis-
played, press to display the pre-
vious/next page. (During
playback you can also use the
front panel
CH +/– buttons.)
During playback, enter a track
number then press
ENTER to
skip directly to that track.
Press
CLEAR to clear a number
entry and start again.
While a PBC menu screen is
displayed, use to select num-
bered menu items.
Note
1 When playing in PBC mode, some playback features, such as search, repeat and program play are not avail-
able. You can play a PBC Video CD/Super VCD in non-PBC mode by starting playback using the Disc Navigator
(see
Using the Disc Navigator with playback-only discs on page 56).
PLAY
STOP
PAUSE
REV SCAN FWD SCAN
PREV NEXT
ABC DEF
GHI JKL MNO
PQRS TUV WXYZ
CLEAR
CLEAR
ENTER
Video CD only: Each press skips
backward/forward progressively
up to a maximum of ten min-
utes forward or three minutes
back. Note that this function
doesn’t work when playing in
PBC mode.
Press to start slow-motion play-
back. Press repeatedly to
change the playback speed (for-
ward only).
While paused, press to advance
a single frame (forward only).
Press to display the disc menu
of a Video CD/Super VCD play-
ing in PBC mode.
CM BACK SKIP
STEP/SLOW
RETURN
DVR745H_IBD_EN.book 54 ページ ２００６年７月２７日 木曜日 午後４時１１分