Psion Teklogix Hand-Held Computer 7530 G2 - Manual (Page 193)

Psion Teklogix 7530 G2 Hand-Held Computer User Manual 165
Chapter 5: Configuration
Decoded (Internal) Scanners
Prefix/Suffix
See “Prefix/Suffix” beginning on page 151.
5.11.3.10 UPC E
Enabled UPC-E
Set this parameter to on to allow “UPC E” bar code scans.
Enabled UPC-E1
Set this parameter to on to allow “UPC-E1” (zero suppressed) bar code scans.
UPC-E And UPC-E1 Check Digit
If you enable one or both of these parameters, a check digit is included with the
decoded bar code data.
UPC-E And UPC-E1 Preamble
When you double-tap on one of these parameters, a dialog box is displayed where
you can choose one of three options for lead-in characters for UPC-E and UPC-E1
symbols transmitted to the host device: System Char – system character transmitted
with the data, Country code and System Char – both the country code (“0” for
USA) and system character are transmitted with the data or None – no preamble is
transmitted. The lead-in characters are considered part of the symbol.
Conv. UPC-E To UPC-A
This parameter converts UPC-E (zero suppressed) decoded data to UPC-A format
before transmission. After conversion, data follows UPC-A format and is affected
by UPC-A programming selections (e.g., Preamble, Check Digit).
Conv. UPC-E1 To UPC-A
This parameter converts UPC-E1 (zero suppressed) decoded data to UPC-A format
before transmission. After conversion, data follows UPC-A format and is affected
by UPC-A programming selections (e.g., Preamble, Check Digit).
Prefix/Suffix
See “Prefix/Suffix” beginning on page 151.