Connecting the mgc+ to the ip network, Connecting the mgc+ to the ip network -13 – Polycom DOC2231A User Manual
Page 25
Advertising
MGC+50/MGC+100 Getting Started Guide
2-13
Connecting the MGC+ to the IP Network
If an IP network Interface card is installed in the MGC+, connect the 8-pin
RJ-45 connector of the LAN network cable to the LAN-323 RJ-45 jack on the
rear panel of the MGC+.
Figure 2-6: LAN IP network connection
The IP network properties must be defined in the Network Services, For details,
see MGC+ Administrator’s Guide, Chapter 3.
Advertising