Planar PD8130 - Manual (Page 26)

Controls and Functions
12 Planar PD8130/PD8150 Installation/Operation Manual
PREL
IMINA
RY
4. Cursor Keys ( , , , )
Use these buttons to select items or settings, adjust settings or switch display
patterns.
ENTER
Press to select a highlighted menu item or confirm a changed setting.
5. Aspect Ratio Selection Button
Press this button repeatedly to select one of the following aspect ratios:
16 : 9: For viewing 16:9 DVDs or HDTV programs in their native aspect ratio.
Letterbox: For viewing LaserDisc movies or non-anamorphic DVDs on a 16:9
screen.
4 : 3: Scales the input signal to fit 4:3 sources in the center of the screen.
4:3 Narrow: Scales the input signal to fit 4:3 sources in the center of the
screen when using an anamorphic lens.
Native: Displays source image in its native resolution without re-sizing or
overscan.
6. MENU
Press this button to show or hide the OSD controls.
7. Memory Preset Buttons (M1 / M2 / M3)
Press to recall settings for the current input from one of three memory
presets. By default, these buttons are assigned as follows: M1 = User
Memory 1; M2 = User Memory 2; 3 = ISF Night. However, you can assign each
button to any memory preset you wish.
8. Picture Adjustment Buttons:
Contrast
Press to adjust white level.
Brightness
Press to adjust black level.
Sharpness (SHARP)
Press to adjust sharpness.
Gamma (GAMMA)
Press to select a gamma curve.
Overscan (OS)
Press to select an overscan mode.
Noise Reduction (NR)
Press to adjust noise reduction level.
9. LIGHT
Press momentarily to activate remote backlighting. Press and hold for five
(5) seconds to illuminate the projector rear panel, to facilitate connecting
cables in a dark room.
10. Picture-In-Picture (PIP) Controls:
PIP
Press repeatedly to activate/deactivate PIP mode or select the desired PIP
image source.
SWAP
Press to swap the PIP image with the active source image.