Planar PD8130 - Manual (Page 48)

Operation
34 Planar PD8130/PD8150 Installation/Operation Manual
PREL
IMINA
RY
4.4
Using Picture-In-Picture
(PIP)
For PIP purposes, there are three groups of inputs
separated by their display modes:
• Video (SD) group: Video, S-Video and SCART
inputs.
• Graphic (HD) group: Component 1, Component 2 and RGB inputs.
• Digital Video group: HDMI 1 and HDMI 2 inputs.
PIP shows one input from any of these groups within or beside one input from
either of the other two groups.
• Press PIP to enable the PIP function. Once enabled, press PIP repeatedly to
select the desired PIP source or turn PIP off.
• Press SWAP to swap the main and PIP images.
For more information, refer to PIP Position on page 55.
For each source, Table 4-1 shows which of the other sources are available as a
PIP source.
Table 4-1. Available Main and PIP Source Combinations
PIP Input Source
VIDEO S-VIDEO SCART COMP 1 COMP 2 RGB HDMI 2 HDMI 1
Main In
put Sourc
e
VIDEO
– – – √ √ √ √ √
S-
VIDEO
– – – √ √ √ √ √
SCART
– – – √ √ √ √ √
COM
P
1
√ √ √ – – – √ √
COM
P
2
√ √ √ – – – √ √
RG
B
√ √ √ – – – √ √
HD
MI
2
√ √ √ √ √ √ – –
HD
MI
1
√ √ √ √ √ √ – –
Notes:
1. “ √” means that that source is available as a PIP source with a given main source; “–”
means that it is not.
2. Disabled sources (refer to Source Enable on page 54) are not available as PIP
sources.
PIP SWAP LIGHT