Planar PD8130 - Manual (Page 69)

Operation
Planar PD8130/PD8150 Installation/Operation Manual 55
PREL
IMINA
RY
PIP Position: To change the position of the PIP image, choose PIP Position from
the System menu; see Figure 4-13. Choose one of the following:
• Top Left: This places the PIP source into a 644x362 designated image area at
the top left of the screen.
• Top Right: This places the PIP source into a 644x362 designated image area at
the top right of the screen.
• Bottom Left: This places the PIP source into a 644x362 designated image area
at the bottom left of the screen-safe area of the DMD.
• Bottom Right: This places the PIP source into a 644x362 designated image
area at the bottom right of the screen-safe area of the DMD.
• Picture-By-Picture: This reduces the designated image area of the Active
source to 921x518 and places it next to the PIP source, which is also in a
921x518 image area. These two images are centered on the screen.
• Split Screen: This is a special mode in which the active source is also used as
the PIP source and placed in a PIP area equal to half the display on the left
side. This results in the right half of the image being the active source and the
left half is the PIP source. The PD8130/PD8150 applies the User Memory 2
settings to the PIP image.
Split-screen mode is useful for viewing “before” and “after” settings for
Sharpness, Noise Reduction and other advanced image parameters. See
Figure 4-14.
Figure 4-13. PIP and PBP areas for 1080p Display
DMD Area 1920x1080
Screen-Safe Area 1842x1036
921x518 921x518
644x362
PIP
(top right)
PBP2 PBP1