Planar PD8130 - Manual (Page 85)

Serial Communications
Planar PD8130/PD8150 Installation/Operation Manual 71
PREL
IMINA
RY
Table 6-2 lists the valid operations commands. For all but Execute functions, the
response from the projector is the command and “= <value>” where <value> is
the current value or “NA” if the value is not available. For Execute functions the
response is the same command. All responses are in UPPERCASE.
Some operations command examples:
Input: op bright ? [CR]
Response: OP BRIGHT = 100 [CR]
Input: op bright + [CR]
Response: OP BRIGHT = 101 [CR]
Input: op bright = 127 [CR]
Response: OP BRIGHT = 127 [CR]
Input: op bright - [CR]
Response: OP BRIGHT = 126 [CR]
Input: op resync [CR]
Response: OP RESYNC [CR]
Input: op sharp.mode = 1 [CR]
Response: OP SHARP.MODE = 1 [CR]
Input: op sharp.simple = 50 [CR]
Response: OP SHARP.SIMPLE = NA [CR]
Input: op sharp.simple ? [CR]
Response: OP SHARP.SIMPLE = NA [CR]
The last three commands show what happens when a control is grayed out. In
this case, the sharpness mode was set to advanced (value = 1) and then the
simple sharpness slider was attempted to be adjusted and queried. The
response was “NA” or not available.
Table 6-2. Serial Commands
Operation Commands Values Notes
aspect = ? 0 = 16:9
1 = Letterbox
2 = 4:3
3 = 4:3 Narrow
4 = Native
memory = ? 0 = User Memory 1
1 = User Memory 2
2 = ISF Day
3 = ISF Night
4 = Default
? only returns a value if
ISF Day or ISF Night is
active, otherwise it
returns NA
save.mem = 0 = User Memory 1
1 = User Memory 2