Planar PD8130 - Manual (Page 7)

Planar PD8130/PD8150 Installation/Operation Manual vii
PREL
IMINA
RY
18. Do not operate lamps beyond the rated lamp life. Excessive operation of lamps beyond rated life could
cause them to explode in rare occasions.
19. Never look directly into the lens when the lamp is on.
Manufacturer’s Name: Planar Systems, Inc.
Manufacturer’s Address: 1195 NW Compton Drive, Beaverton, OR 97006
hereby declares that the products Model Numbers:
PD8130/PD8150
conform with the provisions of:
Council Directive 2004/108/EC on Electromagnetic Compatibility;
EN 55022 “Limits and methods of measurements of radio interference characteristics of information technology
equipment” 1998;
EN 55024 “Limits and methods of measurements of immunity characteristics of information technology
equipment” 1998;
Including:
• EN 61000-4-2 “Electromagnetic compatibility (EMC) Part 4: Testing and measurement techniques Section 2:
Electrostatic discharge immunity test”
• EN 61000-4-3 “Electromagnetic compatibility (EMC) Part 4: Testing and measurement techniques Section 3:
Radiated, Radio-Frequency, Electromagnetic Field Immunity Test”
• EN 61000-4-4 “Electromagnetic compatibility (EMC) Part 4: Testing and measurement techniques Section 4:
Electrical fast transient/burst immunity test”
• EN 61000-4-5 "Electromagnetic compatibility (EMC) Part 4: Testing and measurement techniques Section 5:
Surge immunity test"
• EN 61000-4-6 "Electromagnetic compatibility (EMC) Part 4: Testing and measurement techniques Section 6:
Conducted disturbances induced by radio-frequency fields immunity test"
• EN 61000-4-8 "Electromagnetic compatibility (EMC) Part 4: Testing and measurement techniques Section 8:
Conducted disturbances induced by power frequency magnetic fields immunity test"
• EN 61000-4-11 "Electromagnetic compatibility (EMC) Part 4: Testing and measurement techniques Section
11: Voltage dips, short interruptions and voltage variations immunity tests"
And:
• EN 61000-3-2 "Electromagnetic compatibility (EMC) Part 3, Section 2: Limits for harmonic current emissions
(equipment input current up to and including 16 A per phase)" 2000;
• EN 61000-3-3 "Electromagnetic compatibility (EMC) Part 3, Section 3: Limitations of voltage changes,
voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current up to
and including 16 A and not subject to conditional connection" 1995;
Council Directive 2006/95/EC and amended by M1 and C1 on Low Voltage Equipment Safety;
EN 60950 “Safety of information technology equipment, including electrical business equipment”
Compliance Information
DECLARATION OF CONFORMITY: