Pelco SPECTRA C3412M-D - Manual (Page 21)

C3412M-D (12/08) 21
QUICK PROGRAMMING GUIDE
Access main menu (preset 95). Refer to Accessing Main Menu (Preset 95) on page 21.
Use the joystick to position the cursor beside menu selection.
Note: If your controller does not have a joystick, use the up or down key.
Press Iris Open, the submenu/cursor moves to the right.
Move the joystick up or down to view selections.
Press Iris Open to make a selection.
Press Iris Close to cancel a selection.
ACCESSING MAIN MENU (PRESET 95)
You can call up the main menu on your monitor by programming (setting or creating) preset 95 (preset 28 in AD32-preset
mode).
Programming preset 95 for Pelco’s controllers varies according to the type of controller you are using. Instructions for
programming preset 95 are given below for various Pelco controllers.
CM6700/CM6800
1. Enter the number of the Spectra IV/Spectra IV SE dome system and press the CAM key.
2. Enter 95 and hold the PRESET key for two seconds.
3. In the Edit Preset menu, go to SET and press the ACK key. The main menu appears.
KBD200A/KBD300A (Direct Mode Only)
1. Enter 95.
2. Hold the PRESET key (approximately five seconds) until the main menu appears on the screen.