Pelco SPECTRA C3412M-D - Manual (Page 63)

C3412M-D (12/08) 63
PATTERNS
A pattern is a memorized, repeating series of pan, tilt, zoom, and preset functions that can be
recalled with a command from a controller or automatically by a programmed function (alarm,
park, event, or power-up).
Both 16X and 18X models have one user-defined pattern available. The 22X, 23X, and 35X models
can handle up to eight patterns. Pattern length is based upon memory usage rather than a fixed
amount of time. The complexity of a pattern will determine the amount of storage available to
program other patterns.
Note: In most cases, the memory available will allow for ample time to schedule typical
patterns. If the scheduled patterns are unusually lengthy or complex, there is a possibility that
there may not be enough remaining memory to program all eight patterns for the 22X, 23X, and
35X models.
To program a pattern:
1. Use the joystick to position the cursor beside PATTERN NUMBER. Press Iris Open.
The cursor moves to the right.
2. Move the joystick up or down to view selections. Press Iris Open to enter selection.
3. Use the joystick to position the cursor beside PROGRAM PATTERN.
4. Press Iris Open. The Patterns programming window appears on the monitor.
5. Follow the directions displayed on the monitor.
After a pattern is programmed, the remaining storage percentage is displayed on the screen.
This is the amount of memory available to program the remaining patterns.
To clear a pattern:
1. Use the joystick to position the cursor beside CLEAR PATTERN.
2. Press Iris Open.
3. Follow the directions displayed on the monitor.
To edit the pattern schedule:
The Edit Schedule menu is a duplicate of the Edit Event menu (refer to Event on page 80) with
the following exceptions. In the Edit Schedule menu, the event type cannot be changed. Also,
the Holiday feature cannot be accessed from the Edit Schedule menu.
For instructions on changing the features in the Edit Schedule menu, refer to Edit Event on
page 83.
Note: When programming one or more presets within a pattern, use the normal controller
commands to call a preset. Not all controllers can start all patterns. However, any of the patterns
can be automatically started with park, power-up, event, and alarm functions.
* This setting applies only to Pressurized Spectra IV dome systems.
EXIT
SPECTRA IV
LANGUAGE
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
BACK
EXIT
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<AUX>
<TITLE TEXT>
<ALERT>*
<CLEAR>
<PASSWORD>
<CLOCK>
<EVENT>
DOME SETTINGS
PATTERN NUMBER
<PROGRAM PATTERN>
<CLEAR PATTERN>
<EDIT SCHEDULE>
BACK
EXIT
REFERENCE INFORMATION
PATTERN USAGE
REMAINING
PATTERNS