Pelco SPECTRA C3412M-D - Manual (Page 77)

C3412M-D (12/08) 77
CLOCK
The clock is used to program the current date and time. The date and time set in the Clock menu
is used to program events. The date and time can also be displayed on the monitor when the
menus are not being accessed.
To program the clock, do the following:
1. Use the joystick to position the cursor beside TIME BASE. Press Iris Open. The following are
the settings for time base:
POWER LINE: This is the most accurate time base and is the preferred selection in areas
with a stable power line frequency.
INTERNAL CLOCK: The internal clock should be used in areas where the power line
frequency is not accurate.
a. Move the joystick up or down to view the selections.
b. Press Iris Open to select INTERNAL CLOCK or POWER LINE.
2. Use the joystick to position the cursor beside TIME FORMAT. Press Iris Open. Move the
joystick up or down to view the selections. Select 12 HOUR or 24 HOUR, and then press Iris
Open to confirm the time format.
3. Use the joystick to position the cursor beside SET TIME. Press Iris Open. Scroll through the
hours until the desired time appears. Use the joystick to move the cursor to the right. Scroll
through the minutes until the desired time appears. Press Iris Open to select the time.
4. Use the joystick to position the cursor beside DATE FORMAT. Press Iris Open. Move the
joystick up or down to select MM/DD/YYYY or DD/MM/YYYY. Press Iris Open to confirm
the date format.
5. Use the joystick to position the cursor beside SET DATE. Press Iris Open. Scroll through the
days, months, and years until the desired number appears. Press Iris Open to select the
date.
6. Use the joystick to position the cursor beside DAYLIGHT SAVINGS. Press Iris Open.
The following are the settings for daylight savings:
OFF: Daylight saving time will be turned off.
FIXED DATE: Daylight saving time occurs on the same date each year.
RELATIVE DATE: Daylight saving time occurs on a different date each year, such as the
first Sunday in April.
EXIT
SPECTRA IV
LANGUAGE
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
BACK
EXIT
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<AUX>
<TITLE TEXT>
<ALERT>*
<CLEAR>
<PASSWORD>
<CLOCK>
<EVENT>
DOME SETTINGS
CLOCK
TIME BASE
TIME FORMAT
SET TIME
DATE FORMAT
SET DATE
DAYLIGHT SAVINGS
BACK
EXIT
* This setting applies only to Pressurized Spectra IV dome systems.