Pioneer VSX 920 - Manual (Page 68)

Other connections 10
68
En
1 Switch the receiver into standby and
connect Bluetooth ADAPTER to the
ADAPTER PORT located in the rear panel.
2 Switch on the receiver.
3 Press ADAPTER on the remote control to
switch the receiver to ADAPTER input mode. 1
Pairing Bluetooth ADAPTER and
Bluetooth wireless technology
device
“Pairing” must be done before you start
playback of Bluetooth wireless technology
content using Bluetooth ADAPTER. Make sure
to perform pairing first time you operate the
system or any time pairing data is cleared.
“Pairing” is the step necessary to register
Bluetooth wireless technology device to enable
Bluetooth communications.
2
For more details,
see also the operating instructions of your
Bluetooth wireless technology device.
1 Press TOP MENU.
2 Press ENTER to enter PAIRING.
3 Select the PIN code to be used from 0000/
1234/8888 using /, then press ENTER.
PAIRING blinks.
Important
• You can use any of 0000/1234/8888 PIN
codes. Bluetooth wireless technology
device using any other PIN code cannot be
used with this system.
4 Switch on the Bluetooth wireless
technology device that you want to make
pairing, place it near the system and set it
into the pairing mode.
5 Check to see that the Bluetooth ADAPTER
is detected by the Bluetooth wireless
technology device.
When Bluetooth wireless technology device is
connected:
Bluetooth wireless technology device name
appears in the receiver display.
3
When Bluetooth wireless technology device is
not connected:
NODEVICE appears in the receiver display. In
this case, perform the connection operation
from the side of the Bluetooth wireless
technology device.
6 From the Bluetooth wireless technology
device list, select Bluetooth ADAPTER and
enter the PIN code selected in the step 4.
4
Listening to Music Contents of
Bluetooth wireless technology
device with Your System
1 Press ADAPTER on the remote control to
switch the receiver to ADAPTER input mode.
2 Perform the connection operation from
the side of the Bluetooth wireless technology
device to the Bluetooth ADAPTER.
Note
1 When the Bluetooth ADAPTER is not plugged into the ADAPTER PORT, NO ADAPTER will be displayed if ADAPTER input
mode is selected.
2 • Pairing is required when you first use Bluetooth wireless technology device and Bluetooth ADAPTER.
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology
device.
3 The system can display alphanumeric characters only. Other characters may not be displayed correctly.
4 PIN code may in some case be referred to as PASSKEY.
VSX-920_UCSMXCN_En.book 68 ページ ２０１０年１月２１日 木曜日 午前９時４３分