Porsche 911 Carrera - Manual (Page 185)

Allocating signals to the buttons
Prior to programming the HomeLink for the
rst time
Please follow the operating instructions for the
original hand-held transmitter.
The following process deletes the standard codes
set at the factory. Do not repeat the process if you
program further buttons.
Keep the two outer buttons 1 and 3
depressed for approx. 20 seconds until
light-emitting diode A begins to flash quick-
ly. All programmed signals of buttons 1 to 3
are deleted.
HomeLink with xed code system
1. Press the desired button until the light-emitting
diode begins to flash slowly. You then have
approx. 5 minutes to perform steps 2 and 3.
2. Hold the original hand-held transmitter approx.
0 in. to 12 in. (0 to 30 cm) in front of the
marked position (figure) on the vehicle.
3. Press the transmit button on the original
hand-held transmitter until the fog lights flash
three times (up to approx. 45 seconds).
4. Repeat steps 1 to 3 to allocate other buttons.
Note
Several attempts with different distances between
the vehicle and the original hand-held transmitter
might be necessary.
The fog lights will flash once the 5 minutes have
been exceeded. Programming must be repeated
from the beginning.
HomeLink with changeable code system
1. Allocate the required keys as for the systems
with fixed code (steps 1 to 3).
2. To synchronise the system: Press the pro-
gramming button on the receiver for the
garage door actuator. Afterwards, you usu-
ally have approx. 30 seconds to initiate step 3.
3. Press the allocated HomeLink button twice.
(With some devices, the button to be allocated
must be pressed a third time in order to
complete the setting process.)
4. Repeat the programming steps to allocate
other buttons.
Note
Please consult your authorized Porsche dealer
if you have not been able to successfully
allocate signals for the garage door opener
to the buttons even though you have carefully
followed the instructions in this chapter and
the operating instructions for the original
hand-held transmitter.
To reprogram a single button:
1. Press the desired button until the light-
emitting diode begins to flash slowly (approx.
20 seconds). You then have approx. 5 minutes
to perform steps 2 and 3.
2. Hold the original hand-held transmitter approx.
0 to 30 cm in front of the marked position
(figure) on the vehicle.
3. Press the transmit button on the original
hand-held transmitter until the fog lights flash
three times (up to approx. 45 seconds).
4. Repeat steps 1 to 3 to allocate other buttons.
Controls, Instruments
183