Porsche 911 Carrera - Manual (Page 307)

3. Place socket wrench (tool kit) on the unlocking
spindle. The handle of the wrench should point
horizontally to the rear.
4. Turn socket wrench approx. 180° A. The
headlight is unlocked and pushed forward
slightly during this process.
5. Turn socket wrench back until it is pointing
vertically downward B and leave in position.
6. The headlight is now unlocked and can be
pulled forward out of the fender.
Installing
1. Insert headlight into the guide rails and push
fully into the fender.
2. Push headlight to the rear and at the same
time turn the socket wrench until it points
horizontally to the rear C. The headlight
locking device must perceptibly and audibly
engage.
3. Insert the rubber plug into the unlocking
opening and secure the carpet. Check the
function of all lights.
Low beam, high beam and additional high
beam
Opening the lid of the headlight housing
1. Unscrew the 4 screws A.
2. First lift release tab B, then push both release
tabs C upwards and take off lid.
Practical Tips, Emergency Service
305