Panasonic SA-XR700 - Manual (Page 10)

10
RQT8743
Set speakers and test speaker output
The unit checks each speaker’s connection status and make speaker settings automatically.
• Automatic detection does not work well depending on speakers and cables.
Make speaker settings manually in such cases (á page 33).
• These settings remain effective after the unit goes off.
• The unit considers seven speakers and one subwoofer are connected to the unit (keeps factory settings) unless you perform these steps.
• Perform the above steps when you connect a new speaker.
Detecting speakers automatically
1
To turn the unit on
Press
• The standby indicator “^” goes off when
you turn the unit on.
2 To check the speaker
presence
Press simultaneously.
Automatic speaker detection starts.
“ WARNING ” messages may appear on the display depending on detection results.
The right surround back speaker was detected, but the unit did not detect the left surround back
speaker. Use the terminal for the left speaker when you connect one surround back speaker only
(á page 9).
The unit did not detect left and right surround speakers.
Connect surround speakers as well when you connect surround back speakers to the unit.
The unit did not detect one of the two surround speakers.
Check speaker connections.
Step
3
-MENU/-SETUP ENTER
INPUT SELECTOR VOLUME
BI-AMP SURROUND
SURROUND SPEAKERS
AUTO DETECTOR
TUNE AUX
ADVANCED DUAL AMP
AUTO SPEAKER SETUP
SETUP MIC
HDMI
RETURN
SURROUND SPEAKERS ENTER - MENU/ - SETUP
AUTO DETECTOR RETURN TUNE
AUX S VIDEO VIDEO L - AUDIO - R SETUP MIC
A B
SPEAKERS
AUTO DETECTOR
“ ”
ONE
TOUCH PLAY
DI
RE
CT
NA
VI
GA
TO
R
TO
P
M EN
U
FU
NC
TIO
N
S
0
CH
VOLUME
SKIP SLOW/SEARCH
STOP PAUSE PLAY
DRIVE SELECT MANUAL SKIP
ENTER
SUB MENU RETURN
OFF
SUBWOOFER TV
LEVEL EFFECT VOL
NEO : 6
SFC
MUSIC MOVIE MUTING
TV/AV
DIMMER
-/- - DISC
DIRECT
TUNING
TEST
AUTO
8
A B
SPEAKERS
AUTO DETECTOR
The unit checks the center speaker, surround
speakers, surround back speakers and the
subwoofer in that order.
(The connection status for front speakers is always
present.)
The display shows the number of detected speakers
(excluding the subwoofer).
The display shows connected speakers.
When automatic detection is finished, the display
returns to the original.
(e.g.)
L : Front left C : Center R : Front right S : Surround
SB : Surround back W : Subwoofer
How speakers are displayed
Note
Quic
k guide
ENGLISH
Set speakers and test speaker output
SA_XR700_EG_GN_ (RQT8743_B)ver.3.fm 10 ページ ２００６年８月３１日 木曜日 午前９時７分