Panasonic SA-XR700 - Manual (Page 11)

11
RQT8743
• Unconnected speakers do not output the test signal.
• Check connections and perform automatic speaker detection once again when a connected speaker does not output the test signal.
(á pages 9 and 10)
• When bi-wire speakers are connected (á page 20), press [SPEAKERS A] or [SPEAKERS B] to switch “ ” on.
Testing speaker output
Confirm audio output using the test signal after speakers are set.
1
To select “SPEAKERS A”
Press to switch “ ” on.
• If you select SPEAKERS B only, the test signal will not be
output.
2 To test speaker output
Press
• Adjust the volume of front speakers to the normal
listening level.
• The test signal is output from one speaker at a
time for two seconds in the order shown below.
or
(When you connect one surround back speaker)
3 To stop the test signal
Press
To make detailed settings
To make various settings automatically
With the supplied setup microphone, the unit sets speaker distances, polarity, size,
lowpass filter, frequency and levels automatically (á page 22).
To set speakers the way you like
“Adjusting speaker volumes” (á page 29)
“Setting speakers and their sizes” (á page 33)
“Setting distances” (á page 33)
“Setting the lowpass filter” (á page 33)
A
SPEAKERS
A
A B
SPEAKERS
When SPEAKERS A and
SPEAKERS B settings are
selected
A
SPEAKERS
When only the SPEAKERS A
setting is selected
TEST
AUTO
SBR SBL LS SW RS C L R
SB LS SW RS C L R
Speaker
How speakers are displayed
L : Front left C : Center R : Front right
RS : Surround right LS : Surround left
SBR : Surround back right SBL : Surround back left
SB : Surround back
(When you connect one surround back speaker)
SW : Subwoofer
TEST
AUTO
Note
A B
A B
SPEAKERS
BI-WIRE
Set speakers and test speaker output
ENGLISH
Quic
k guide
SA_XR700_EG_GN_ (RQT8743_B)ver.3.fm 11 ページ ２００６年８月３１日 木曜日 午前９時７分