Paradyne IP DSLAM GranDSLAM 4200 - Manual (Page 16)

1. Installation
1-6 January 2004 4200-A2-GN20-40
Mounting Configurations
Three basic installation configurations are available:
„ Rack mount – see Installing the Brackets for Rack Mounting on page 1-6 and
Installing the GranDSLAM 4200 Into a Rack on page 1-8.
„ Wall mount – see Installing the GranDSLAM 4200 on a Wall on page 1-10.
„ Shelf or desktop – see Installing the GranDSLAM 4200 on a Shelf or Desktop
on page 1-12.
Mounting Brackets
Your GranDSLAM 4200 can be installed in a rack or on the wall using mounting
brackets. Two brackets suitable for a 19-inch (483 mm ) rack (marked EIA-19) and
two brackets suitable for a 23-inch (584 mm) Bay Networks or Nortel rack (marked
with Paradyne Part Number 868-6282-0120) are shipped with the unit. Two
brackets suitable for a 21-inch (535 mm) rack (marked ETSI) are available from
Paradyne as a separate feature (see
Appendix B, Equipment List ).
Rack-mounting brackets may also be used to attach the unit to a wall.
NOTE:
In this guide, the term rack refers to any rack, cabinet, frame, or bay suitable
for mounting telecommunications equipment.
Installing the Brackets for Rack Mounting
Procedure
To install the mounting brackets for rack mounting:
1. Locate the black screw nearest the front panel on each side of the unit as
shown.
2. Remove these two black screws (one from each side) before attempting to
install the mounting brackets.
02-17274
1
12 13
24
DSL POR TS 1-24
POTS 1-24
4 8
16 20
POWER A
ALARM
RTN -48V DC
BITS MGMT
CONSOLE
ST A TUS UPLINK
ALRM TEST
B
A
3.5 A 60
B
E1 MODULE 4202 TX RX
120Ω
75 Ω