Paradyne IP DSLAM GranDSLAM 4200 - Manual (Page 48)

4. Configuration
4-4 January 2004 4200-A2-GN20-40
GranDSLAM 4200 Turn-Up Procedure
You can turn up your GranDSLAM 4200 through the Ethernet connection via a PC
or terminal connected to the unit’s CONSOLE port. Then, using a series of TL1
commands, GrandVIEW EMS or another Element Management System, or the
web interface, you can configure the unit according to your requirements.
The turn-up procedure for the GranDSLAM 4200 system differs depending on the
type of management used:
„ Inband Management – Operates over the ATM interface. This is the default for
the GranDSLAM 4200.
„ Out-of-Band Management – Operates over the Ethernet interface.
The turn-up procedure for both management types differs depending on whether
you are in Manual mode (no DHCP server), or in DHCP (BOOTP) mode using a
DHCP server.
„ Manual Mode – If a DHCP server is not being used, you must manually assign
an IP address to your GranDSLAM 4200.
„ DHCP Mode – If you are using a DHCP server, you do not need manually
assign an IP address since this is done automatically.
Login and TID
Upon initial login, the unit has a Target IDentification (TID) of six blanks. There is
only one user defined, with a User ID of SUPERUSER and a password of
ASN#1500. Login using the command:
ACT-USER::SUPERUSER:100::ASN#1500;
Next, if required to distinguish it from other units, assign a unique TID. In this
example, the TID is TAMPABAY1:
SET-SID:::100::TAMPABAY1;