Pentax K200D - Manual (Page 247)

245
Appendix
12
Shake
Reduction
does not work
The Shake
Reduction function
is off
Turn on the Shake Reduction switch. (p.68)
The Shake
Reduction function
is not set properly
If a lens for which focal length information
cannot be acquired is used, set the [Focal
Length] on the [Input Focal Length] menu.
(p.69)
Shutter speed is
too low for the
Shake Reduction
function to be
effective when
panning or
shooting night
scenes, etc.
Turn off the Shake Reduction function and
use a tripod.
The subject is too
close Move away from the subject, or turn off the
Shake Reduction function and use a tripod.
In rare cases, the camera may not operate correctly due to static electricity.
This can be remedied by taking the batteries out and putting them back in
again. When the mirror remains in the up position, take the batteries out and
put them back in again. Then, turn the power on. The mirror will retract. After
the procedure is done, if the camera operates correctly, it does not require any
repairs.
Problem Cause Remedy