Premier PHP HWC-260 - Manual (Page 10)

Premier Heat Pumps – Water Heater and Chiller Manual
Page 10
3-2 Water connections
Please refer to the diagram below:
1) Connect the hot water in pipe (hot water supply pipe) to the outlet port on the
hot water cylinder. Pay attention to heat preservation and ensure appropriate
thermal insulation of the pipe work. It is important that the unused hot water
outlet port be properly capped. The plastic transport caps are not suitable for
this function.
2) Install a water filter (where necessary) and one-way valve in the tap water (
inlet water pipe) and then connect the tap water pipe (inlet water pipe) to the
inlet port on the tank.
3) Fill the tank with water. Open the tap water (inlet water) in-valve allowing the
tank to fill with water; Meanwhile, open the hot water out-valve, until the water
spills over from the hot water out valve. Once this happens the tank is full of
water. Close the tap water (inlet water) in-valve, check and ensure that there
is no leakage in the system. Re open all valves.
Attention: Be sure the tank is full of water before it is switched on.
Warning: The inlet and outlet plastic caps are for transport only. Any
unused inlet or outlet ports must be blanked off properly using compliant
metal pipe caps.