Premier PHP HWC-260 - Manual (Page 5)

Premier Heat Pumps – Water Heater and Chiller Manual
Page 5
! Caution !
Do not climb on the unit or try to move
it once installed. Keep out of reach of children. Do not
allow them to play on or near the unit.
Do not place foreign objects or fingers
into the air inlet/outlet. The fan runs at
high speed and can cause serious
injury. Do not operate the unit without
the safety grill in place. Important: Ensure that the plug remains
clean, free from moisture, foreign objects
and dirt. Ensure that the plug is properly
inserted or hard wired by a qualified
electrician.
If the unit operates abnormally, stop
the unit by firstly switching it off and
then unplug the unit. For example, if
there is a strange smell or abnormal
noise coming from the unit.
Do not clean the appliance with water.
Water will go into the unit and will destroy
the insulation.
Turn the unit off at the wall before
unplugging the unit. Do not disconnect
the power while the unit is running. Do not pull on the cable to unplug the
unit, damage to the plug and cable could
occur
Do not touch the plug with wet hands,
as electric shock can occur.
Ensure that the power to the heat pump is
disconnected before removing leaves,
particles or other foreign objects from the
air inlet vanes.
Verify the network specifications, with the unit data recorded on the heat pump
prior to installation.
Any additional disinfectant systems, such as chemical or electrolysis are not
recommended for use with this hot water heat pump. The pump MUST be installed
prior to these systems.
For optimal operation of the heat pump, the following maximum values apply:
A. Use of free chlorine : max : 2.6mg/l
B. Total bromine : max : 5.6mg/l
C. pH : between 6.5 and 8.0