Panasonic KX-FC195AL - Manual (Page 57)

8. Programmable Features
55
1. Press {MENU}.
2. Press {#}, then {6}{0}.
3. Press {A} or {B} repeatedly to select “ ON”.
4. Press {SET}.
5. Enter the transfer telephone number.
6. Press {SET}.
7. Press {MENU}.
Code #61: Checking, recording or erasing the
transfer greeting message
TRNS-GREETING
CHECK [ ±]
See page 49 for details.
Code #67: Setting the incoming message
monitor
ICM MONITOR
=ON [ ±]
To hear an incoming message (ICM) from the
speaker when the answering device is recording
the message.
“
ON” (default): You can monitor the incoming
message.
“
OFF”: Deactivates this feature.
Code #68: Setting the Error Correction Mode
(ECM)
ECM SELECTION
=ON [ ±]
This feature is available when the
transmitting/receiving fax machines are ECM
compatible.
“
ON” (default): To send a fax even if there is static
interference on the telephone line.
“
OFF”: Deactivates this feature.
L
You cannot change the setting when received
documents are in memory.
Code #70: Calling your pager
PAGER CALL
=OFF [ ±]
See page 50 for details.
Code #76: Setting the connecting tone
CONNECTING TONE
=ON [ ±]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones;
fax tone, ring back tone and busy tone. You can
use these tones to confirm the status of the other
party’s machine.
L If the ring back tone continues, the other
party’s machine may not be a facsimile or
may have run out of paper. Check with the
other party.
L The connecting tone volume cannot be
adjusted.
“ ON” (default): You will hear connecting tones.
“ OFF”: Deactivates this feature.
Code #77: Changing the receiving mode in
the auto answer setting
AUTO ANSWER
=TAD/FAX [ ±]
“ TAD/FAX” (default): Telephone Answering
Device/Facsimile mode (page 39)
“
FAX ONLY”: Facsimile only mode (page 39)
Code #80: Resetting advanced features to
their default settings
SET DEFAULT
RESET=NO [ ±]
To reset the advanced features:
1. Press {MENU}.
2. Press {#}, then {8}{0}.
3. Press {A} or {B} repeatedly to select “ YES”.
4. Press {SET}.
5. Press {SET} again.
6. Press {MENU}.
L ECM selection (feature #68, page 55) will
not be reset.
Features (Handset)
8.4 Handset programming
To exit programming, press {ih} any time.
Time alarm settings
Set the time and date on the handset beforehand
(page 23).
{>}{e}{v}
{j}
{ih}
{ C}
FC195AL.book Page 55 Tuesday, November 18, 2003 10:28 AM