Panasonic KX-FC195AL - Manual (Page 69)

10. Help
67
properly, contact our service personnel to
have the unit repaired. If the working
telephone does not operate properly, contact
your telephone company.
The unit does not ring.
L The ringer volume is turned off. Adjust it
(page 21, 22).
L The ring setting of feature #06 is set to
“
RINGER OFF”. Change to another ring
setting (page 52).
The base unit rings even when its ringer
volume is set to off.
L Handset(s) is not hung up. Press {ih}.
The unit displays “ CHECK PAPER” though the
paper is inserted.
L The paper is inserted halfway. Insert it
correctly (page 17) and press {START} to
clear the message.
The other party complains they only hear a
fax tone and cannot talk.
L FAX ONLY mode is set. Tell the other party
the number is only used for faxes.
L Change to TEL mode (page 38) or TAD/FAX
mode (page 39).
The {REDIAL/PAUSE} / {R} button does not
function properly.
L If this button is pressed during dialling, a
pause will be inserted. If pressed
immediately after a dial tone is obtained, the
last number dialled will be redialled.
The receiving mode does not function
properly.
L The Distinctive Ring is set (feature #31, page
41).
During programming, I cannot enter the code
or ID number.
L All or part of the numbers are the same.
Change the number: feature #11 (page 52),
#41 (page 53), #51 (page 54) and #52 (page
54).
The ink film runs out quickly.
L The help printing function, copy function, and
reports also use ink film.
The unit beeps.
L Recording paper or ink film has run out.
Press {STOP} to stop the beeps and install
paper/ink film.
The speakerphone is not working.
L Use the speakerphone in a quiet room.
L If you have difficulty hearing the other party,
adjust the volume.
The {LOCATOR/HOLD} button does not
function.
L The handset is too far from the base unit.
L The handset is engaged in an external call.
10.3.2 Cordless handset
The handset display is blank.
L The handset is not turned on. Turn the power
on (page 18).
The handset does not work.
L Make sure that the batteries are installed
correctly (page 17).
L Charge the batteries fully (page 20).
L Clean the charge/battery contacts and
charge again (page 20).
L Turn the handset power off, then on (page
18).
Battery icon is not counting up while
charging.
L Clean the charge/battery contacts and
charge again (page 20).
L The power cord is disconnected. Plug in the
power cord.
0w4 is flashing.
L The handset is not registered to the base
unit. Register it.
L The handset is too far from the base unit.
Move closer and try again.
L The power cord is not connected. Check the
connections.
A busy tone is heard when {C} is pressed.
L The handset is too far from the base unit.
Move closer and try again.
L The base unit or another handset is in use.
Wait for the other user to complete the call.
L Another handset is not hung up after being
used. Press {ih} on that handset.
I cannot dial out.
L Call BAR mode is set. Turn it off (page 58).
L The dialled number is restricted. Remove the
number from the call restricted list (page 60).
L Key lock mode is on. Turn it off (page 27).
FC195AL.book Page 67 Tuesday, November 18, 2003 10:28 AM