Panasonic KX-FC195AL - Manual (Page 60)

8. Programmable Features
58
of a language. Each menu will be displayed
as an alphanumeric code. The Command
Interface codes for each menu item are
shown on page 59.
Call option settings
Setting the call BAR
This feature prohibits outgoing calls. When call
BAR is turned on, only emergency calls and
intercom calls can be made.
1. Press {j}.
2. Press {e} or {v} repeatedly to display
“ SETTING HS”.
3. Press {>}.
4. Press {e} or {v} repeatedly to display
“ CALL OPT”.
5. Press {>}.
6. Press {e} or {v} repeatedly to display
“ CALL BAR”.
7. Press {>}.
8. Enter the 4-digit handset PIN (Personal
Identification Number).
L The default PIN is “ 0000”.
9. Press {e} or {v} repeatedly to select the
desired setting.
“
ON”: The call BAR feature is available.
“ OFF” (default): Deactivates this feature.
10. Press {>} or {j}.
11. Press {ih}.
Note:
L While this feature is activated, the following
will be displayed.
L If you turn this feature on, receiving faxes with
the handset may not be possible (page 39).
Setting the direct call number
After the direct call number is set and this feature
is set to on, you can dial the direct call number
simply by pressing {C}. You can receive
incoming calls even if this feature is set.
1. Press {j}.
2. Press {e} or {v} repeatedly to display
“ SETTING HS”.
3. Press {>}.
4. Press {e} or {v} repeatedly to display
“ CALL OPT”.
5. Press {>}.
6. Press {e} or {v} repeatedly to display
“ DIRECT NO”.
7. Press {>}.
8. Enter a direct call number, up to 24 digits.
L To correct a mistake, press {C}. Digits are
cleared from the right.
9. Press {j} 3 times.
10. Press {ih}.
Changing the direct call setting
1. Press {j}.
2. Press {e} or {v} repeatedly to display
“ SETTING HS”.
3. Press {>}.
4. Press {e} or {v} repeatedly to display
“ CALL OPT”.
5. Press {>}.
6. Press {e} or {v} repeatedly to display “ SET
DIRECT”.
7. Press {>}.
8. Press {e} or {v} repeatedly to select the
desired setting.
“
ON”: The direct call feature is available.
“ OFF” (default): Deactivates this feature.
9. Press {>} or {j}.
10. Press {ih}.
Note:
L While this feature is activated, the following
will be displayed.
L When this feature is activated, you cannot
receive faxes using the handset (page 39).
Other option settings
Changing the handset PIN (Personal
Identification Number)
The handset’s PIN is set at the factory to “
0000”.
If you change the PIN, please write down your
new PIN as the unit will not reveal the PIN to
you. If you forget your PIN, consult your
nearest Panasonic service centre.
1. Press {j}.
2. Press {e} or {v} repeatedly to display
“ SETTING HS”.
3. Press {>}.
4. Press {e} or {v} repeatedly to display
“ OTHER OPT”.
FC195AL.book Page 58 Tuesday, November 18, 2003 10:28 AM