Panasonic KX-FC195AL - Manual (Page 58)

8. Programmable Features
56
Setting the time of alarm
1. Press {j}.
2. Press {e} or {v} repeatedly to display
“ SETTING HS”.
3. Press {>}.
4. Press {e} or {v} repeatedly to display
“ TIME ALARM”.
5. Press {>}.
6. Press {e} or {v} repeatedly to display “ SET
TIME”.
7. Press {>}.
8. Enter the desired hour/minute by selecting 2
digits for each (24 hour clock entry).
L To clear, press {C}.
9. Press {>}.
10. Press {e} or {v} repeatedly to select the
desired setting.
“
ONCE”: Alarm will ring only once.
“ REPEAT DAILY”: Alarm will ring at the set
time everyday.
“
OFF” (default): Deactivates this feature.
11. Press {>} or {j}.
12. Press {ih}.
Note:
L Time alarm will sound for 3 minutes.
L To stop the alarm, press any dialling buttons.
L When in talk or intercom mode, the alarm will
not sound until the call is ended.
Changing the time alarm frequency
1. Press {j}.
2. Press {e} or {v} repeatedly to display
“ SETTING HS”.
3. Press {>}.
4. Press {e} or {v} repeatedly to display
“ TIME ALARM”.
5. Press {>}.
6. Press {e} or {v} repeatedly to display “ SET
ALARM”.
7. Press {>}.
8. Press {e} or {v} to select “ ONCE”, “REPEAT
DAILY” or “OFF”.
9. Press {>} or {j}.
10. Press {ih}.
Ringer option settings
You can select the following ringer settings.
Ringer volume: See page 21.
Ringer patterns for external calls / internal
calls / paging / alarm: There are 20 patterns
available for each ringer. To change the ringer
patterns, proceed as follows.
1. Press {j}.
2. Press {e} or {v} repeatedly to display
“ SETTING HS”.
3. Press {>}.
4. Press {e} or {v} repeatedly to display
“ RINGER OPT”.
5. Press {>}.
6. Press {e} or {v} repeatedly to display the
desired item.
For external calls, select “
EXT RINGER”.
For internal calls, select “ INT RINGER”.
For paging, select “ PAGING”.
For alarm, select “ ALARM”.
7. Press {>}.
8. Press {e} or {v} repeatedly to select the
desired setting from pattern “ 1” (default) to
“ 20”.
9. Press {>} or {j}.
10. Press {ih}.
Note:
L If you select one of the melody ringer
patterns, the ringer will continue to sound for
10 seconds when the caller hangs up before
you answer. You may hear a dial tone or no
one on the line when you answer a call.
Tone option settings
You can set the following tone/alarm on or off.
Key tone: Key tones, a confirmation tone or an
error tone will sound. The default setting is “
ON”.
Call waiting tone: A call waiting tone will sound
when an external call is received during an
intercom call. The default setting is “
ON”.
Range warning alarm: An alarm will sound
when you move out of range of a base unit. The
default setting is “
OFF”.
Battery low alarm: An alarm will sound when
the batteries need to be charged. The default
setting is “
ON”.
1. Press {j}.
2. Press {e} or {v} repeatedly to display
“ SETTING HS”.
3. Press {>}.
FC195AL.book Page 56 Tuesday, November 18, 2003 10:28 AM