Panasonic MN103001G/F01K - Manual (Page 310)

Serial Interface
13-8
Serial 0 interrupt mode register
Register symbol: SC0ICR
Address: x'34000804
Purpose: This register selects the sources for transmission interrupts and reception interrupts for serial
interface 0.
Bit No. 7 6 5 4 3 2 1 0
Bit SC0
- -
SC0
-
SC0
-
SC0
name DMD TI RES RI
Reset 0 0 0 0 0 0 0 0
Access R/W R R/W R/W R R/W R R/W
Bit No. Bit name Description
0 SC0RI Reception interrupt factor selection
0: Reception end 1: Reception end with error
1 — "0" is returned when this bit is read.
2 SC0RES Reception error interrupt factor selection
0: Interrupt request when an overrun, parity, or framing error occurs
1: Interrupt request when a parity error occurs
3 — "0" is returned when this bit is read.
4 SC0TI Transmission interrupt factor selection
0: Transmission end 1: Transmission buffer empty
5 Reserved Setting "1" is prohibited.
6 — "0" is returned when this bit is read.
7 SC0DMD Data output retained during external clock transmission (valid only in clock
synchronous mode)
0: Set data pin "H" at end of transmission
1: Maintain data pin at end of transmission
Serial 0 transmission buffer
Register symbol SC0TXB
Address:
x'34000808
Purpose: This register writes the transmission data of serial interface 0.
Bit No. 7 6 5 4 3 2 1 0
Bit SC0 SC0 SC0 SC0 SC0 SC0 SC0 SC0
name TXB7 TXB6 TXB5 TXB4 TXB3 TXB2 TXB1 TXB0
Reset 0 0 0 0 0 0 0 0
Access R/W R/W R/W R/W R/W R/W R/W R/W
Data is transmitted by writing it to this buffer.