Pioneer DVR-220 - Manual (Page 12)

Connecting up 02
12
En
Chapter 2
Connecting up
Rear panel connections
1 ANTENNA IN/OUT
Connect your TV antenna to the ANTENNA IN jack. The
signal is passed through to the ANTENNA OUT jack for
connection to your TV.
2 OUTPUT jacks
Stereo analog audio, video and S-video outputs for
connection to a TV or AV amplifier/receiver.
3 AV1(RGB)-TV AV connector
Audio/video output SCART-type AV connector for
connecting to a TV or other equipment with a SCART
connector. The video output is switchable between video,
S-video and RGB. See page
AV1 Out on page 82 for how
to set this up.
4 AV2/AUTO START REC (INPUT 1/DECODER) AV
connector
Audio/video input/output SCART-type AV connector for
connecting to a VCR, or other equipment with a SCART
connector. The input accepts video, S-video and RGB.
See
AV2/L1 In on page 82 for how to set this up.
5 CONTROL IN
Use to control this recorder from the remote sensor of
another Pioneer component with a
CONTROL OUT
terminal and bearing the Pioneer mark. Connect the
CONTROL OUT of the other component to the
CONTROL IN of this recorder using a mini-plug cord.
6 DIGITAL OUT OPTICAL
For connecting to an AV amplifier/receiver, Dolby Digital/
DTS/MPEG decoder or other equipment with optical
digital input.
7 AC IN – Power inlet
Front panel connections
On the left side of the front panel a flip-down cover hides
a second audio/video input, consisting of an S-video and
standard (composite) video jack, and stereo analog
audio jacks.
DVR-320 only: On the right side is the DV input/output
i.LINK connector. This is for connection to a DV
camcorder.
DIGITAL OUT
AC IN
OPTICAL
CONTROL
IN
IN OUT
ANTENNA
R L
AUDIO VIDEO S-VIDEO
OUTPUT
AV 2/AUTO START REC
(INPUT 1/DECODER)
AV 1 (RGB) - TV
1 3 2 4 5 6 7
PULL-OPEN
VIDEO/R/RW
VIDEO S-VIDEO
PULL-OPEN
VIDEO/R/RW
DV IN/OUT
DV IN/OUT
DVR-04_UK.book 12 ページ ２００４年４月１１日 日曜日 午後５時２０分